CHUTE COVER PROTECTIVE DEVICE FOR INDOOR CSF-3 CAT FEEDER

Optional protective chute cover for CSF-3 CAT SUPER FEEDER (INDOOR USE ONLY) This chute cover has been modified slightly to allow passage of standard cat food kibbles. Best performance is with 1/4" round/square kibbles--Not recommended with kibbles larger than 1/4" thick by 1/2" long, although it may work fine with other sizes depending on shape. Perfect for indoor cat feeder use. If you have had problems with pet intrusion into other feeders, this is guaranteed to work on the Super Feeder...there always is a way to prevent that problem with the Super Feeder. NOTE: AT CHECK OUT, BE SURE TO SCROWL DOWN MOST ECONOMICAL SHIPPING MODE--FEDEX OR USPS PRIORITY MAIL FOR THIS PRODUCT.

If you unfortunately you have a "locksmith" type cat, then this is without a doubt the answer! This optional protective cover originally designed for outdoor Super Feeders has been modified slightly to accommodate and protect the indoor Cat feeder perfectly. It DOES NOT normally come installed on the CSF-3 because you must read its limitations and be aware that you must use the correct size kibbles to prevent your pet from not being fed due to clogging, should you use oversized food. Although we have tested our CSF-3 and chute cover with typical size and shape cat food like "Special Kitty" or "Science Diet" with outstanding results, WE RECOMMEND THAT YOU TEST and use the SMALLEST suitable cat food when using this cover to assure best performance and dependability. Typical small 1/4" round/square kibbles like offered by SCIENCE DIET ARE PERFECT! Guaranteed to work! Most customers don't need it, but if you have a real mischievous cat, this is the answer to a potential chute intrusion problem commom with many other feeders. NOTE! THIS CHUTE COVER IS FOR INDOOR USE ONLY (outdoor one is available). If it is ordered at same time as the feeder, the price includes factory installation. if not, you will need to follow the instructions below to install it later: WHILE HOLDING FEEDER UPSIDE-DOWN, REMOVE BOTTOM OF FEEDER BY UNSCREWING THE 6 SMALL STAINLESS STEEL SCREWS, MOVE SHAKER WIRE OUT OF WAY, MOVE DISTRIBUTION SLIDE OUT OF THE WAY, THEN SLIDE CHUTE COVER STRAIGHT INTO THE CHUTE OPENING. RE-INSTALL IN REVERSE ORDER BY MAKING SURE SHAKER WIRE IS AGAINST BOTTOM OF SLIDE. THE CHUTE COVER DOES NOT SNAP IN OR OUT, SO DO NOT TRY TO PULL IT OUT OR FORCE IT IN WITHOUT REMOVING FEEDER BOTTOM OR YOU WILL BREAK IT!! INSTRUCTIONS WILL BE INCLUDED WITH THE CHUTE COVER ORDER.

Manufacturer: N/A
SKU:	CC-02
MPN:	Super-Feed